Detection Problem on AWARD BIOS

This time I will share information about the problems in the AWARD BIOS are:
1 long beep
Problems with memori.Kemungkinan is improperly installed memory or a memory chip mobo rusak.Bisa also damaged.

1 long beep and 2 short beeps
Video.BIOS system error can not write video to display error messages kelayar.Ada kemungkinan.Anda put some existing VGA Card VGA VGA onboard.Atau fight each IRQ to the VGA device mounting cardnya lainnya.Mungkin also less true.

1 long beep and 3 short beeps.
Same as the above (no.2).

Connecting connect beep
Caused by memory or VGA card


For handling the Award BIOS is almost the same as the most important AMI.Yang you have to be patient and careful in diagnosing faults. In addition there are several other steps to deal with this BIOS, among them are:
1. If your PC will not boot at all, make sure that the minimum components have been installed, the processor, VGA card, memory and a drive.Serta make sure that everything is installed properly.
2. Remove components are not required, such as expansion cards, external peripherals such as printers, scanners, etc. it, because improper installation cause I / O errors. Then turn on the system and try attaching one by one to test it.
3. Double check the jumper settings on the mainboard. Make sure the type of processor, bus speed, multiplier and voltage jumpers. Also make sure the BIOS jumper position on the state should (normally).
4. Change the BIOS settings to default, to make sure there are no errors in the settings.
5. Check all cables connected to the motherboard if it is correct, both the data cable and power connector.
6. Check whether there is excessive heat components (particularly processors.) If any change BIOS settings or jumpers to a lower setting.

Hopefully Helpful :)